With the myAVR Stamp, microcontroller solutions can be developed and tested in the MK3 environment.
The myAVR Stamp is designed as a plug-in daughter board and can therefore be installed into a desired target system as a finished embedded controller after a successful test.
It has a JTAG, ISP and Mini USB port for communication and programming. With the Micro SD card holder, additional applications are available.
MicroSD card holder
Mini USB connection
AVR 8-Bit Microcontroller
until 16 MHz
Operatin voltage: 1,8 - 5,5 V
Flash: 256 KByte, 10.000 times reprogrammable
EEPROM: 4 KByte, 100.000 times reprogrammable
RAM: 8 KByte
I/O lines: 86
Two 8-bit-Timer / Counter
Four 16-bit-Timer / Counter
Four 8-bit PWM (pulse with modulator)
12 PWM lines with 2-16 Bit
16 10-bit analog digital converter
4 serial interfaces RS232, byte orientated
6 sleep modes
with preinstalled bootloader
USB connection happens via standard IC (CP2102 onboard) and provides PC-sided a comport for the data
compact and functional microcontroller modul
with standard USB interface and microSD card holder
no annoying SMD soldering is necessary!
5 V power supply, optional via
the JTAG- / ISP interface or
via the board on which is the stamp
Industrial standard controller (CP2102 onboard)
Programming is possible via
USB and the bootloader or
JTAG and ISP
The installed bootloader makes a firmware update possible via the USB connection
=> no programmer is necessary!
You can use the microSD card as bulk memory or for data communication with other systems (e.g. the PC).
With it you can manage and work with websites, graphics, pictures, texts and many more.
Underneath of the myAVR Stamp256 PLUS there are 2 female connectors to install the stamp in other systems.
Through the plug connection (female connector and multi-pin connector) you can install the stamp anywhere in
The multi-pin connectors which are suitable for the stamp are not in the scope of supply. You can also buy them