Description: less content
The myAVR ProgTool is a free software to program AVR microcontroller. With it, you be able to program and readout Fuse/Lock-bits, EEPROM and also the Flash of the controller. You can any copy this tool and can be published. The functions of this tool are extraction of myAVR products that is subject to license. Please note: The myAVR ProgTool uses the LibUSB driver 0.1.12.1. That's in need of some Atmel programmer, eg the AVR ISP MKII or the AVR Dragon.
Since V1.30, the ProgTool has been supporting the mySmartUSB light.

Description: less content
The firmware simpleTerminal is a small program for the mySmartControl M8/M168. It allows you to set, delete and change the bits of the used ports. It is required for the realisation of projects such as the example project "LED-Matrix". To use it just copy the firmware to the mySmartControl. To do this you can use the following software: myAVR Prog Tool, myAVR WorkPad SE/PLUS or SiSy AVR.

Description: less content
With that firmware the USB-programmer mySmartUSB MK2 command of an extended support for older controller types of Atmel; exhibit a faster trasnmission rate for the programming and is able to select automatically slower transmission rates, if fusebits were put for example on slow clock sources Furthermore this firmware version has an extended TWI-functionality. For users of AVRDUDE 5.3 an extended configuration file is contained with the corresponding DEVICE codes.

Description: less content
To use the extended abilities of the mySmartUSB firmware you will need special tools from myAVR. One of this is the mySmartUSB Terminal. It’s used for executing the steps to create a TWI or SPI protocol and to observe the succession of the actions and feedbacks. This version makes possible activating the RESCUE Mode of the mySmartUSB.
In the TWI-textbook the mySmartUSB Terminal is used for analysis of the TWI protocols.
mySmartUSB Terminal requires firmware version 2.5 or higher for mySmartUSB MK2.